Replacing 3x SAS disk RAID on a Perc6 controller, with a single SSD connected to the motherboard SATA ports, I needed to perform the following steps; otherwise I would get a BSOD on booting.
Run regedit
Edit the following keys so that the value is 0 instead of 3
(Windows 7)
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Msahci\Start
(Windows 8)
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\storahci\Start
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\IastorV\Start
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\atapi\Start
Reboot, then change the BIOS settings in the from RAID to RAID/ACHI Autodetect
Make sure the SATA ports are enabled in the BIOS
Apply the BIOS settings, then reboot.
No comments:
Post a Comment